- TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK MANUAL
- TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK PRO
- TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK PC
- TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK DOWNLOAD
- TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK WINDOWS
Click the Close button to exit the Ethernet0 Properties window.
TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK WINDOWS
To access Windows Firewall, click Settings > Network & Internet > Ethernet > Windows Firewall > Turn Windows Firewall on or off. Windows Firewall should be re-enabled after the tests have been completed. Note: To test TCP/IP connectivity between the PCs, Windows Firewall must be disabled temporarily on both PCs. Step 4: Verify IPv4 connectivity between the two PCs. Click OK > Close to exit the Ethernet0 Properties window. Select the Use the following IPv4 address and enter the IPv4 address 192.168.1.1 and subnet mask 255.255.255.0.In the Ethernet0 Properties window select Internet Protocol Version 4 (TCP/IPv4) and click the Properties button.On PC-A right click the Ethernet0 icon in this example and click Properties.
TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK MANUAL
TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK PC
Try unplugging the cable from one PC then reconnecting it to verify that the light goes off then back on. A link light (usually green or amber) indicates that physical connectivity has been established between the two NICs. After the Ethernet crossover cable is connected to both PCs, take a close look at each Ethernet port.As you insert the cable, you should hear a click which indicates that the cable connector is properly inserted into the port. Plug the other end of the cable into the Ethernet NIC of PC-B. Plug one end of the cable into the Ethernet NIC of PC-A.The following instructions assume you are using a crossover cable. Note: (optional lab setup) The PCs may be connected to a switch using two straight-through cables. Obtain an Ethernet crossover cable provided by the Answers to connect the two PCs.
Step 1: Connect the PCs to create a peer-to-peer network. If auto-MDIX is enabled on a PC or switch interface, either Ethernet cable types can be used to connect the devices. 1 Ethernet cross-over cable to connect the PCs (provided by Answers)Īnswers Note: A switch may be used to connect the PCs using two straight-through cables.2 PCs (Windows 10) with at least one wired Ethernet NIC on each PC.You will assign various IPv4 addresses to the hosts and determine the effects on their ability to communicate. In this lab, you will build a simple peer-to-peer network using two PCs and an Ethernet crossover cable. Assign various IPv4 addresses to hosts and observe the effects on network communication.Build a simple peer-to-peer network and verify physical connectivity.Upon passing, certificates and wallet cards can be ordered from the LabSim home page for a minimal fee.Last Updated on Februby Admin 3.4.4.3 Lab – IP Addresses and Network Communications Answers Lab – IPv4 Addresses and Network Communication ( Answers Version)Īnswers Note: Red font color or gray highlights indicate text that appears in the Answers copy only.
TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK DOWNLOAD
TESTOUT LAB 2.1.3 CONNECT TO AN ETHERNET NETWORK PRO
The TestOut PC Pro certification exam is a culminating exam that instructors may offer students.These tasks will not impact an examinees’ final score. Examinees may encounter a small number of unscored tasks that are used to evaluate and improve the exam.